Motor driver H-Bridge partial
I envision a design based on the ST TD340 (page 19 of attached spec.) utilizing the power MOSFET IRF3709S (attached spec.) with external PWM-Signal (provided), separate external controller supply 20-30VDCRead More
I envision a design based on the ST TD340 (page 19 of attached spec.) utilizing the power MOSFET IRF3709S (attached spec.) with external PWM-Signal (provided), separate external controller supply 20-30VDCRead More
This is a Sponsored Post, The contributions from these Sponsor Firms help enhance and improve the delabs websites and services. The speed controller of collector motors on the TDA1085 chipRead More
Here i am listing the last few parts in this Interface discussion. Only Points to remember are listed. Resistors attenuate voltage or reduce. Current flow has to be limited. TheRead More
message: Greetings, I have a kit motor controller. I works just fine. It uses the NE556. I read some where ( on a NE555 )that I can change one ofRead More
The following was submitted on February 1st, 2006 at 08:49AM (PST).- Subject: delabs Schematic Source Request. Circuit: speed motor control dc mail from MD Study Resources Below Speed Controllers – The purposeRead More