Current Source for Resistance Measurement
Here is a current source you can build for resistance measurement. When the current is held constant, you know as per Ohm’s Law the Voltage across Resistor is proportional to Resistance value. The supply...
Tagged: Circuit-Design
Buffer or Unity Gain Op-Amp
If output impedance of a point is a high value then connecting another circuit at that point will load it resulting in malfunction or error. Buffers are used as interface between circuits. Low impedance...
RS Latch Erroneously setting by Itself
I am having trouble preventing my rs latch from erroneously setting. The circuit is a voltage threshold detection circuit with a nand gate whose output is tied to a SR latch. I have capacitors...
Polarized Capacitors and 555
Howdy! This circuit of yours is EXACTLY what I was looking for. TOTALLY cool! However, I have a few questions about it…mostly because I’m a software guy. Astable 555 Timer Flasher. So please bear with...
Button and four LED Lights
Need a design – Simple one button push button to turn on 4 different LED (3mm Dome) every time you press the button. 555 Circuits, LED Schematic. User Interface Design. JE USA Attached is...
WorkBench Dual Power Supply
I will just explain part of this circuit. D9 and D10 provide a low cost -1.4 from -5 V. This is needed to reach near 0.00 for LM317 Min. setting. An LED also can...
Analog Dial Amps-Volts-Ohms meter
This was designed, keeping in mind, that sometimes we have few components available and you could not carry your DMM somewhere, but you have to make some instrument for a quick need with what...
Simple Sample and Hold with CD4066
A sample and hold is like an analog memory. If The digital control A is low 4066 switch is open, and when A is high switch is closed. U2B is a buffer so as...
Digital Counter – 4029 and 4511
I just about the circuit you made. what kind of IC is 4029N & 4511N? Is it a diver/decoder? I tried to research on the datasheet but it cannot give exact specification…
Digital Programmable Gain Amplifier
I read your post which is about, Digital gain control of Op-amp. I have some questions to ask, if possible. Please reply ASAP. I am student and I have a lab project to work...
Single Polarity Power Supply
This circuit uses a PNP Power Transistor TIP2955, you can use any other according to your current and voltage requirement. Look at R2 a 10 Ohm resistor, when the current in your load to...
Isolated Full-duplex Serial Interface
I would like to build Optoisolated RS232 interface. I’vesearched a little bit, and I came across your design:
