Digital gain control of Opamp.

Advertise in delabs

The gain of U1 can be controlled by a digital binary 1248 nibble at ABC. The gain at digital 000 is unity or 1 and the gain at various stages are set by 4051.

Precision Attenuator with Digital Control – delabs

There are eight different gains as the steps of gain resistor network is chosen by 4051. The on resistance of 4051 channel around 100E gets added to U1 pin 2 internal impedance.

Digital gain control of Opamp

Auto ranging 4-1/2 Digit Digital Voltmeter – delabs

You can use separate resistor networks with trimpots for each channel if you require but keep the networks total burden on U1 pin 6 to around 10K, not less than than. You can use this to set the gain of a amplifier with the help of a microcontroller.

More delabs Schematic Diagrams

  • Switching Battery Charger with L296Switching Battery Charger with L296
    This is a a circuit from my  Power Supplies Section.  There may be some documentation errors in my circuits. If you are used to building [...]
  • Using Thermocouple with DMM or DVMUsing Thermocouple with DMM or DVM
    In the circuit, use only metal film resistors (MFR) of 1 per cent tolerance, as this is an instrumentation application. Power supply should be a [...]
  • Ammeter and Precision RectifierAmmeter and Precision Rectifier
    Studying current measurement is a prerequisite for many of the measuring techniques. The current parameter mainly specifies the power consumption in a circuit, given the [...]
  • RTD Pt-100 Four Point AlarmRTD Pt-100 Four Point Alarm
    Here 4052 is used as an analog multiplexer, U3A TL062 opamp is wired as a 1mA Constant Current Source. It pumps 1mA into U2 4052 [...]
  • Square and Triangle Opamp OscillatorSquare and Triangle Opamp Oscillator
    Here is the circuit of a Op-Amp based Square Wave Generator. One of the main application of this is in a Simple PWM circuit and [...]
  • Voltage to Frequency Converter AD InterfaceVoltage to Frequency Converter AD Interface
    This is the Analog front end of the 80C39 Process Controller. The analog input is protected by a Zener barrier, low leakage. You could use clamping diodes [...]
  • Analog Level by BCD Thumbwheel SwitchAnalog Level by BCD Thumbwheel Switch
    BCD Thumbwheel Switch is used to input-set data in digital form, this can be read by digital circuits, uC and uP systems and PLC-SCADA Interfaces. [...]
  • Voltage Doublers and MultipliersVoltage Doublers and Multipliers
    Voltage multipliers are used to obtain low current high voltage, from an existing AC Source. Step up transformers can be used, but the insulation problems [...]
About delabs 152 Articles
Product Design - Industrial Automation and Instrumentation. -

Be the first to comment

Leave a Reply