RTD 3-W Mains Power 4-20 mA Transmitter

Advertise in delabs

This is the Photo of a RTD 3-W Mains Powered Temperature 4-20mA Transmitter. The Circuits and PCB are here RTD PT100 Transmitter and Multiplexer.The Circuit RTD-Pt-100-Transmitter.

We can classify Transmitters as shown below. The Measured Parameter Temperature, Flow or Events Has to reach an Intelligent Data Storage and Analysis System. It may just be an Human Operator who jots the data on a Notepad and Turns a Few Dials based on his Experience or an embedded controller. It could even be a Computer Network or a Web Application used.

RTD PT100 Transmitter and Multiplexer PCB

  • Analog Transmitters – Like 4-20mA Loop.
  • Electrically Isolated Analog Transmitters.
  • Transmitters that need to be Intrinsically Safe.
  • Digital Transmitters and Optical Interface.
  • Wireless Transmitters and TCP-IP.

The job of the transmitter is to take the weak analog measured parameter information from sensor, be close to it, amplify, clean, linearize the signal if required and send strong – error free data over a long distance to an operator or system.

Process Control Instruments and Custom Solutions has been my core Strength. The RTD Pt-100 Transmitter with 4-20 mA output shown here was used in numbers with a 4-20 mA Analog Multiplexer. This was in turn monitored/controlled by a PLC SCADA System to monitor many points in a large Industrial Plant. The external multiplexer makes unlimited channels possible with a Standard Analog Input and Digital Output Module.

More delabs Schematic Diagrams

  • Connection Diagram of AC Control SSRConnection Diagram of AC Control SSR
    SSR or Solid State Relay or Electronic Relay Connection Method. This is a Thyristor Based Normally Open 230V Switch that can be turned on / [...]
  • Display ICL7107 – Temperature controllerDisplay ICL7107 – Temperature controller
    This is the Display Circuit and PCB part of of section Temperature Control. The above circuit is powered by +5 and -5 from a LM7805 [...]
  • Two Op-Amp Differential AmplifierTwo Op-Amp Differential Amplifier
    The Input Impedance of this module is very high and is symmetric. This circuit can be used for strain gauges and for four wire measurements. [...]
  • Single Polarity Power SupplySingle Polarity Power Supply
    This circuit uses a PNP Power Transistor TIP2955, you can use any other according to your current and voltage requirement. Look at R2 a 10 [...]
  • Interface a uC to PC RS232 with MAX232AInterface a uC to PC RS232 with MAX232A
    This is the standard configuration on how to Interface a uC like 8051 to PC RS232 with MAX232A. The UART or Serial port was not [...]
  • Milli Volt Source for Printer PortMilli Volt Source for Printer Port
    This circuit uses a R-2R Ladder Resistor Network to convert digital data from PC Printer Port to Analog. This can be used as a Millivolt [...]
  • RTD Pt-100 Four Point AlarmRTD Pt-100 Four Point Alarm
    Here 4052 is used as an analog multiplexer, U3A TL062 opamp is wired as a 1mA Constant Current Source. It pumps 1mA into U2 4052 [...]
  • Single Digit Voltmeter with LM311Single Digit Voltmeter with LM311
    I wanted to design a logic probe as a tutorial, but there were many good ones in the web so i have tried to design [...]
About delabs 152 Articles
Product Design - Industrial Automation and Instrumentation. -

Be the first to comment

Leave a Reply