Normally Closed AC SSR

Advertise in delabs

This is a Normally Closed PCB Mount SSR. That means when DC Control input is low, the triac is ON, the output passes the load current to turn on small heater-motor-lamp or a bigger contacter-drive etc.

NC AC Load SSR DC control

When input DC is high the output is OFF. This is also Optically Isolated from Mains. A Microcontroller output which is buffered by some driver can drive this relay. It is better that in big systems these SSR Modules can be on another PCB, to avoid mains wiring near Logic circuits. But this cannot be used for medical electronics, or critical applications. More reliability and visual isolation of voltages may be required for such equipment.

More delabs Schematic Diagrams

  • Pulse width modulation using 555Pulse width modulation using 555
    IC1 astable gives a fixed square wave at pin 3, C1 and R1 derive uS trigger pulses from IC1 and this will trigger IC2 monostable [...]
  • Simple Millivolt Source for CalibrationSimple Millivolt Source for Calibration
    This is a modification of a mV Source that can be whipped up easily. You could use a DPM or Multimeter to read the output. [...]
  • Three Opamp Differential InstrumentationThree Opamp Differential Instrumentation
    This is the best Instrumentation OpAmp, Great CMRR, ensure supply has no ripple and keep analog and digital grounds separate. Ri can be replaced with [...]
  • Interface ICL7135 Voltmeter to Atmel 89C52Interface ICL7135 Voltmeter to Atmel 89C52
    This circuit is a Parallel interface between 89C52 of Atmel with 7135 of Intersil.  With This circuit you can read analog data of both polarities. [...]
  • 555 based Reset Generator555 based Reset Generator
    You must have read all the circuits and explanation on the other pages at delabs to understand this, as i cannot repeat the same thing [...]
  • Timer and Counter ModulesTimer and Counter Modules
    U1 CD4541 is a Timer with Long Duration Ability. This timer is started by a low pulse from earlier circuit, when the temperature goes above [...]
  • FET Current Source and MOSFETFET Current Source and MOSFET
    This is a constant current source using a FET. This is the most simple replacement to series resistor to limit current. The N-Channel FET BF256C [...]
  • LED Voltage Level IndicatorLED Voltage Level Indicator
    This circuit is derived from a Siemens Application Note 1974. This circuit uses common components of today. The circuit is here as it is of [...]
About delabs 152 Articles
Product Design - Industrial Automation and Instrumentation. -

Be the first to comment

Leave a Reply