Tubelight Electronic Choke

Advertise in delabs

This is an electronic choke for a Conventional Fluorescent Lamp. This was an application note of MJE13005 a High Voltage Switching NPN Power Transistor. I Might have modified it. This was very popular in the early days, The Coil Winding and Ferrite is very Critical design.

Emergency Light with Fluorescent Tubes

Tubelight Electronic Choke

Low Cost Simple CFL lamp

The diodes, npn transistor and caps are high voltage 350V-1KV, The tubelight is 40W-60W 5 feet long. This circuit replaced the choke and starter in an existing frame.

More delabs Schematic Diagrams

  • Telephone status indicator with LEDTelephone status indicator with LED
    This will monitor telephone status without loading the telephone line, this way if you have two phones in parallel you will know if one of [...]
  • Millivolt Source with Digital PotentiometerMillivolt Source with Digital Potentiometer
    Variable Parameters like voltage, current can be obtained by using a Digital Potentiometer. Microcontrollers or Counters operate FET CMOS Analog Switches. The switches configure resistor [...]
  • Build a DMM – LM3914 Analog displayBuild a DMM – LM3914 Analog display
    This a part of a complete Benchtop DMM that you can build to learn the internals of a Digital MultiMeter. This is oriented towards learning [...]
  • Ammeter and Precision RectifierAmmeter and Precision Rectifier
    Studying current measurement is a prerequisite for many of the measuring techniques. The current parameter mainly specifies the power consumption in a circuit, given the [...]
  • Interface ICL7135 Voltmeter to PCInterface ICL7135 Voltmeter to PC
    A PC based Analog Voltmeter. The Printer Port or Parallel Port Interface is used to acquire high resolution analog data using ICL7135. This is a [...]
  • Crystal Oscillator – Parallel ResonantCrystal Oscillator – Parallel Resonant
    74HCU04 is a chip that was made for this purpose, HCT may not work for such a circuit. C1 and C2 can go to upto [...]
  • Triac based Lamp Dimmer power controlTriac based Lamp Dimmer power control
    This is a phase angle control of a Triac which is a evolution from an SCR. The 50 Hz or 60 Hz Sine wave of [...]
  • 0-1V to 4-20 mA Converter0-1V to 4-20 mA Converter
    This two opamp circuit converts analog voltage signals to current (sink) signals in a proportional manner. Current signals are more immune to noise and cross [...]
About delabs 152 Articles
Product Design - Industrial Automation and Instrumentation. -

Be the first to comment

Leave a Reply