Differential to TTL convertor using LM339

Some outputs are via Dual Differential Line Driver type DS8830. This device will interface with standard TTL systems.

Differential to TTL convertor using LM339

The differential outputs are balanced and are designed to drive long lengths of coaxial cable, strip line, or twisted pair transmission lines with characteristic impedances of 50 ohms to 500 ohms. Differential transmission is superior to single wire transmission in that it nullifies the effects of ground shifts and noise signals which appear as common mode voltages on the transmission line.

Mixed and Interface Circuits

If the signal voltage at the end of the line is found to be of insufficient magnitude then the following circuit may be used (at the recipient equipment end) to boost the levels.

  • Buffer or Unity Gain Op-AmpBuffer or Unity Gain Op-Amp
    If output impedance of a point is a high value then connecting another circuit at that point will load it resulting in malfunction or error. [...]
  • Precision Op-Amp Current SourcePrecision Op-Amp Current Source
    In this circuit we tackle the error indicated in the earlier Current Source. The LM336-2.5V eliminates the tiny error of the regulated supply and resistors. [...]
  • Sample and Hold with Standby CD4053Sample and Hold with Standby CD4053
    A, B, and C are the Digital Control for x, y and z input and output pairs.The voltage at Vinx is stored in C1 when [...]
  • 3-1/2 Digit ICL7107 DPM Digital Panel Meter3-1/2 Digit ICL7107 DPM Digital Panel Meter
    This is a Digital Panel Meter based on ICL7107. This was the workhorse Digital Readout chip before Low power uC designs were developed. Even now [...]
  • Edison Bulb Life ExtenderEdison Bulb Life Extender
    The Edsion Filament lamp may be less popular, but it is the most cost-effective light even today. It is very affordable, The light is soothing [...]
  • Simple Digital Event CounterSimple Digital Event Counter
    The basic digital circuits are Flip Flop and Counter, both are here. This circuit can be cascaded to make even a 6 digit event counter, [...]
  • Non-Inverting Amplifier – Op-Amp CircuitsNon-Inverting Amplifier – Op-Amp Circuits
    The input impedance of this module is very high, if U1 is OP07 it is in mega ohms, use CA3140 or LF356 fet input opamps [...]
  • Power supply with battery backup – DMMPower supply with battery backup – DMM
    This is a simple charger circuit which will work for a light load like a DMM, the Battery can be a sealed maintenance free battery [...]
About delabs 152 Articles
Product Design - Industrial Automation and Instrumentation. -

Be the first to comment

Leave a Reply