Sample and Hold with Standby CD4053

A, B, and C are the Digital Control for x, y and z input and output pairs.The voltage at Vinx is stored in C1 when A goes high, when A is low the voltage stored in C1 is read by buffer U2A.

It could be used in DMM circuits as Analog Memory DMM range, AC-DC mode, logic control

Sample and Hold with Standby CD4053

Another application of  Mux 8 Channel 4-20mA Analog Multiplexer

The stby or standby input should be low when sample and hold is operating. If stby is taken high then C1 Cap is isolated and leakage is minimum. The supply of +/- 7.5V is chosen as OFF resistance of 4053 is high at this supply.

  • Insulation Tester pico amplifier
    With these circuits you can make an insulation tester going upto two tera ohm, hence currents will be in pico amps, great care required in [...]
  • Mains Voltage Indicator with a LEDMains Voltage Indicator with a LED
    This is a mains 230V AC voltage indicator and is a LIVE CIRCUIT, so take care. The Resistor has to be a fusible ceramic wire [...]
  • Simple Printer Port InterfaceSimple Printer Port Interface
    Printer Port Circuit to see the inputs logic state and drive a few outputs. The preset control program helps test out the circuit operation. Use [...]
  • Square and Triangle Opamp OscillatorSquare and Triangle Opamp Oscillator
    Here is the circuit of a Op-Amp based Square Wave Generator. One of the main application of this is in a Simple PWM circuit and [...]
  • Battery Backup for SRAM or Microcontroller
    This circuit can be used as a low cost SRAM and Microcontroller-Microprocessor Battery Backup. All the diodes are 1N4148, The diodes prevent battery discharge back [...]
  • Blind Dial Analog Temperature ControllerBlind Dial Analog Temperature Controller
    This is a Low cost controller, Analog Dial Temperature Controller. It is also called Blind Controller. This essentially means Open Loop, just control the fuel [...]
  • Proportional Module for Process Controller
    When you need a proportional control output, either 4-20mA or Time Proportional On-Off, This module is used. It does a slow PWM control, the cycle [...]
  • 555 multivibrator like power oscillator
    This is dual 555 multivibrator like power oscillator. This is my contraption and conception but couple of decades old. It appears to have errors. It [...]
About delabs 160 Articles
Product Design - Industrial Automation and Instrumentation. -

Be the first to comment

Leave a Reply