Differential to TTL convertor using LM339

Some outputs are via Dual Differential Line Driver type DS8830. This device will interface with standard TTL systems.

Differential to TTL convertor using LM339

The differential outputs are balanced and are designed to drive long lengths of coaxial cable, strip line, or twisted pair transmission lines with characteristic impedances of 50 ohms to 500 ohms. Differential transmission is superior to single wire transmission in that it nullifies the effects of ground shifts and noise signals which appear as common mode voltages on the transmission line.

Mixed and Interface Circuits

If the signal voltage at the end of the line is found to be of insufficient magnitude then the following circuit may be used (at the recipient equipment end) to boost the levels.

  • Thermocouple Amplifier Standard
    Thermocouple is the most common sensor in Industrial Temperature Measurement. The Signal Conditioning involves Cold Junction Compensation and High Gain DC Amplification. The output of [...]
  • Two Stage Sequential TimerTwo Stage Sequential Timer
    This is an example of a cascaded or sequential timer, here two CD4541 are forming a two stage timer. You can add more in a [...]
  • Passive volume control with PotentiometerPassive volume control with Potentiometer
    Volume control circuit for speaker 4 ohm or 8 ohm located in the another room far away. by using only passive components. This gives limited control [...]
  • AC conversion and Continuity – DMM
    U1A LF353 opamp turns on a buzzer when the voltage at Test + falls very low indicating a short between Test + and Test – [...]
  • Battery Backup SupplyBattery Backup Supply
    This is a 9V power supply which will work even on power failure. It uses a rechargeable battery and regulators. A transformer with 15-0-15 AC [...]
  • Analog Mux for Data Acquisition Systems
    Here is a 4-20 mA In/Out Analog Mux with Cascade option. This is a simple circuit i designed to make a Automation System within a [...]
  • Printer Port Logic AnalyzerPrinter Port Logic Analyzer
    This is a Test Circuit for Logic Analyzer software, with the Simple port circuit. The VB Logic Analyzer works, but is just an example program [...]
  • Mains Voltage monitor using LM3914
    This Circuit helps in the monitoring of mains supply voltage. It does not use a isolation step down transformer. This has to be constructed only [...]
About delabs 160 Articles
Product Design - Industrial Automation and Instrumentation. -