Connection Diagram of DC PCB SSR

This is an Application note i used to give with my ssr – app012.pdf

Diagram of SSR 5000 DC 3-30 Control / 230V AC N.O. @ 3A.

This is a Thyristor Based Normally Open 230V Switch that can be turned on / off at a fast rate. This switches at Zero Crossover . Use 5V DC for Best Results.

  • No moving parts hence no wear and tear.
  • Dissipates Heat when in On Condition 5 Watts @ 3 Amps.
  • Mount with adequate Air Ventilation for 3 Amps.
  • Dissipation is 1.4 Watts per Amp thru Load.
  • Input to Output is optically isolated 1kV.
  • This one is DC 3-30 Control AC 230V N.O. Output.
  • Off state snubber Leakage is around 1 mA.

Notes –

The Termination’s of High Current Lines going to Load must be very tight and crimped. Loose contacts will Spark and cause Fire.

Fast Blow Fuse is to be used. Use a 2 Amps Fuse with Holder in the Hot Line. This diagram applies to all AC SSR with DC Control

  • 100kHz Half Bridge Convertor – SG3525
    This is a SMPS Circuit application very close to the Application Note in the book SGS Motion Control Application Manual. This worked well. Read about [...]
  • Millivolt Source – Field Calibration Current LoopMillivolt Source – Field Calibration Current Loop
    This is easy to rig millivolt source for field calibration or troubleshooting of 4-20 mA current loops. Here a Darlington pair is used for current [...]
  • Microohm Meter with LED Analog BarMicroohm Meter with LED Analog Bar
    This indicates like LM3914 in dot-mode. It is a drawing i made made to troubleshoot a gadget, around two decades ago. Strangely it had a [...]
  • Li-Ion Battery ChargerLi-Ion Battery Charger
    This circuit is built around LM3647 an Universal Battery Charger, This Circuit is an untested design. It is based on application hints and was provided [...]
  • 5V -1A Power Supply using LM25755V -1A Power Supply using LM2575
    A Power Transistor which is having a drop of 4 Volts across it and passing 3 amps thru it, may dissipate around 12 Watts of [...]
  • WorkBench Dual Power SupplyWorkBench Dual Power Supply
    I will just explain part of this circuit. D9 and D10 provide a low cost -1.4 from -5 V. This is needed to reach near [...]
  • Timer and Counter ModulesTimer and Counter Modules
    U1 CD4541 is a Timer with Long Duration Ability. This timer is started by a low pulse from earlier circuit, when the temperature goes above [...]
  • EMI RFI Mains Filters
    EMI RFI Filters are required in two situations, to prevent EMI from an Electronic Equipment Like A Dimmer, Thyristor Drive, SMPS or Switcher affecting other [...]
About delabs 160 Articles
Product Design - Industrial Automation and Instrumentation. -

Be the first to comment

Leave a Reply