Buffer or Unity Gain Op-Amp

If output impedance of a point is a high value then connecting another circuit at that point will load it resulting in malfunction or error. Buffers are used as interface between circuits. Low impedance of an output means it can source sink lot of current, when you need 2 opamps use LF353 or TL072 which are dual opamps.

Blind Dial Proportional Temperature Controller

A non-inv FET input is the best buffer, for inverting buffer use high R values Using very high R values like 2.2M or higher requires a glass epoxy PCB and guard rings around pin 2, 3 to prevent leakage currents on the PCB reaching the PINs. Also moisture and dust has to be prevented by using RTV coating or Varnish. Use 78L05 79L05 for the dual supply required by this circuit.

Buffer or Unity Gain Op-Amp

Vout = -(Vin) for inverting

Vout = Vin for non-inverting

 

  • LM311 Square Triangle Oscillator for PWMLM311 Square Triangle Oscillator for PWM
    LM311 is a comparator, It operates from single 5V supply or dual supplies,input current 150 nA, 50 V-50 mA output drive capability. TTL-CMOS compatible output. [...]
  • Analog Dial  Amps-Volts-Ohms meterAnalog Dial Amps-Volts-Ohms meter
    This was designed, keeping in mind, that sometimes we have few components available and you could not carry your DMM somewhere, but you have to [...]
  • Constant Current Source for LEDConstant Current Source for LED
    This article will explain the way a simple transistor based current source is designed, this will give an idea on how some components can be [...]
  • 555 watchdog for uC and uP systems555 watchdog for uC and uP systems
    When the microcontroller hangs due to a spike, EMI or RFI etc. the 7555 will reset the uC, if proper power supply design is done [...]
  • Ammeter and Precision RectifierAmmeter and Precision Rectifier
    Studying current measurement is a prerequisite for many of the measuring techniques. The current parameter mainly specifies the power consumption in a circuit, given the [...]
  • Voltage to Frequency Converter ICL8038Voltage to Frequency Converter ICL8038
    This was a small circuit made for driving an Impact counter. The heart being ICL8038. It must have been a Motor driving a Conveyor, the [...]
  • Differential Amplifier – Op-Amp CircuitsDifferential Amplifier – Op-Amp Circuits
    This amplifies the difference between two inputs Vp and Vn the low impedance of this configuration is a drawback, but can be used in analog [...]
  • Simple Sample and Hold with CD4066Simple Sample and Hold with CD4066
    A sample and hold is like an analog memory. If The digital control A is low 4066 switch is open, and when A is high [...]
About delabs 152 Articles
Product Design - Industrial Automation and Instrumentation. -

Be the first to comment

Leave a Reply