Battery Backup Supply

This is a 9V power supply which will work even on power failure. It uses a rechargeable battery and regulators. A transformer with 15-0-15 AC volts output is required.

From my Power Electronic Circuits

In the first regulator U1 the output is lifted up by 1.4V and in the second regulator U2 by a resistor divider. In the second regulator the voltage across resistor R3 is 5V, so the current is 5V / 1K = 5mA this adds to the quiescent current of 5mA from the regulators ground terminal and flows into the resistors R1 and R2 in parallel which form 404 ohms, 10mA thru 404 ohms is 4V. So the output will be 5 + 4 = 9V. Note that the charge and discharge paths of the battery are separated with diodes.

  • Thermocouple Amplifier StandardThermocouple Amplifier Standard
    Thermocouple is the most common sensor in Industrial Temperature Measurement. The Signal Conditioning involves Cold Junction Compensation and High Gain DC Amplification. The output of [...]
  • Simple High speed data switchSimple High speed data switch
    This circuit is a small representation of a very low cost printer sharer. It has no Active Devices only diodes. Pot the product in epoxy [...]
  • DC-DC SSR Solid State RelayDC-DC SSR Solid State Relay
    This is a DC Input DC Output SSR Solid State Relay. It was made for Printing or Photo Processing Equipment. It has an optical isolation [...]
  • Transistor Beta and Vce Tester
    This was a Beta Hfe and Vce Measuring Instrument used in Incoming Inspection of Power Transistors made by me 16 years back. Custom Built Test [...]
  • Opamp Supply on Buffered Virtual GroundOpamp Supply on Buffered Virtual Ground
    When a Inverting Opamp Configuration is at a steady state, we say the Inverting Input is at a Virtual Ground. That means it is at [...]
  • Connection Diagram of AC Control SSRConnection Diagram of AC Control SSR
    SSR or Solid State Relay or Electronic Relay Connection Method. This is a Thyristor Based Normally Open 230V Switch that can be turned on / [...]
  • Blind Dial Analog Temperature ControllerBlind Dial Analog Temperature Controller
    This is a Low cost controller, Analog Dial Temperature Controller. It is also called Blind Controller. This essentially means Open Loop, just control the fuel [...]
  • Power Supply with Battery BackupPower Supply with Battery Backup
    This is an incomplete version of the power supply used for the Alertness Monitor with hourly LED Display. This circuit used a Dual Color LED. [...]
About delabs 160 Articles
Product Design - Industrial Automation and Instrumentation. -

Be the first to comment

Leave a Reply