• Tech Ads

Printer Port Logic Analyzer

This is a Test Circuit for Logic Analyzer software, with the Simple port circuit. The VB Logic Analyzer works, but is just an example program to test and learn.

Printer Port Logic Analyzer

The speed at which the logic state changes say like 10 M Hz while probing even a PIC or 89C51, is too fast for this circuit. For that, the incoming data has to be spooled or stored in RAM at real time, by the external Hardware itself.

Test Circuit for Logic Analyzer software – del20006

As this is a Parallel Port Interface, an Embedded High Speed Digital RAM Storage of Multiple Logic input Channels with Signal Conditioning in the front end, could do the job. This is the minimum, if you want to program the rest of the instrument on Computer Software. Here is one you can see from Bitscope using USB or Ethernet.

Simple Printer Port Interface

Printer Port Circuit to see the inputs logic state and drive a few outputs. The preset control program helps test out the circuit operation. Use safe 5V Levels.

Simple Printer Port Interface, Input-Output – del20005

So i made some example circuits and VB programs for students. A demo Milli Volt source, Digital Voltmeter and Logic Analyzer examples for learning, are on these pages. I have tried to derive power from PC itself in this circuit, Care should be taken not to short circuit or apply any voltages above 5V to PC Port Pins.

Simple Printer Port Interface

74HCT373 is the only chip used to interface the real world with the PC Parallel port. The Inputs to this chip are protected with Resistors and Zeners. 3 outputs of PC are also monitored using LEDs. This gives you a IO interface for experimenting. Below is a Preset counter simulation that you can use with this circuit for testing. Schmitt Triggers and Signal Conditioning may be required for Noisy and Non-Sandard Inputs.

Triac based Lamp Dimmer power control

This is a phase angle control of a Triac which is a evolution from an SCR. The 50 Hz or 60 Hz Sine wave of mains can be turned on at any point after the Zero Crossing.

Design Notes – Power Electronics – 03

Triac based Lamp Dimmer power control

The Voltage ramps up in the sine wave which gives a near “Linear” slope which can be used to trigger the ON at a time delay after zero crossing when the voltage is zero. This is like a PWM but works on low frequency only. Some of the early SMPS(HV for TV and Mains Inverter) by Siemens were built around SCRs. Turning off a SCR is a difficult job for a designer, MOSFETS and IGBT are now used for PWM drive stages.

High Energy Circuits

You can use it with a bulb to vary brightness of bulb, this is a live circuit it can give a shock, enclose in plastic box, the pot should have a plastic knob, use a fuse, you can also use it for temperature control of soldering irons.

The Source file in CadSoft EAGLE format is here del00004.zip