• Tech Ads

555 multivibrator like power oscillator

This is dual 555 multivibrator like power oscillator. This is my contraption and conception but couple of decades old. It appears to have errors. It worked but the document fixing after design worked, not done. This can be used to make a small inverter, for powering 230V gadgets of low power. The transformer is used in step-up mode. It may make a sound if the laminations are not of good quality.

This circuit can be modified using 7555 and switching transistors like BD139 driving a Ferrite 100 kHz transformer to build a Fluorescent Lamp of 10W to 20W.

From Schematics of delabs

Fluorescent lamps can be fired and lit at high frequency at relatively lower voltages. Experiment both with frequency and pulse width to get nominal lighting at good efficiency. One of the reasons CFL lamps -230V and emergency lamps 12V fail, is failure of the switching devices. These have to be overrated thrice or more, the switching heat dissipation should not be underestimated, during low/high voltage and keep a aging allowance.

Designing a working circuit is no big deal. But making a batch of reliable and robust power electronics products, which are idiot proof and abuse resistant is a challenge for engineering. Then they will need it at an affordable price too… Checkmate !

Interface ICL7135 Voltmeter to Atmel 89C52

This circuit is a Parallel interface between 89C52 of Atmel with 7135 of Intersil.  With This circuit you can read analog data of both polarities. You can change the range scale with extra circuits, you can store data on a EEPROM or send them to PC thru RS232 or Comm port.

Using Linux in Embedded Electronic Devices

The Circuit Is Shown for One Anode Drive and one Segment Drive for Display. In similar Fashion connect rest, all 5 anodes and 7 segments and one dp decimal point. The +5 V of 2N2907 and gnd of BC547 must be directly from regulator with a big cap or even a separate supply.

AT89C52 Parallel Interface to ICL7135

Parallel interface is faster that a serial interface.It is more “Real Time” for a given processor and clock speed. The code and accompanying hardware also can speed up the data acquisition.

AT89C52 Parallel Interface to ICL7135 РComplete Page

A single maxim chip can act as a good interface between the uC and Serial Port. You could also do this with Logic chips but correct levels and isolation cannot be achieved, Hence better to use use these interface chips.

These days USB and Wireless Interfaces are being used and Tablet Computers becoming Popular. The Interfacing of the future is “Device Networking” and Wireless may be common.