• Tech Ads

Regulated Power Supply 30V 5A

This is a Regulated 0-30 V DC Power Supply manufactured by me in small numbers, 0-30V 5A and 5V -5A. It had a Switching Preregulator. This keeps the Vce across Transistor Bank at the Back of Instrument, at the lowest possible level, in order to keep them Cool. When Vce and Ic both are more in a Power transistor it will get heated more, then the efficiency of power supply is low.

Variable Regulated Power Supply

The Output had both Constant Current Control and Constant Voltage Control. The CC control is also a Short circuit protection. The Output was protected from outside voltages damaging output circuits even when equipment is switched off. The back panel is a finned anodized black aluminum heat sink with many transistors.

I looked for the circuits to scan them, i could not find it. I made-n-sold quite a few of them years ago. All of them work well even today as i over-rated most components. The cabinet was Steel for EMI-RFI Immunity, it was painted with Stipple Matt Powder Coating, the Cabinet maker had just learnt to give such a finish to his boxes.

Read more

Study these applications at IRF Applications and ST Application Segments.

Transistor Beta and Vce Tester

This was a Beta Hfe and Vce Measuring Instrument used in Incoming Inspection of Power Transistors made by me 16 years back.

Transistor Beta Tester

Custom Built Test Instruments

I designed and built many custom “engineered” Test Instruments. They were not prefect, as only one or two were fabricated. That means it will be costly to produce such instruments. It is just like tooling, you have to make some numbers to recover costs, or price it very high to compensate for the wastages and iterations.

Tera Ohm Meter and Insulation Tester

This is a 20 Tera Ohm Insulation Tester I made around 20 Years Back. It had even Polarization Index for Transformer Insulation. It generated 1000V DC Regulated Voltage and the pA leakage Current was Measured. See more here Insulation tester or Tera ohm meter.

Insulation Tester

A regulated, low ripple, high voltage of very low current capability is applied by instrument on a DUT (device under test). The leakage current in nA or pA (picoamps, nanoamps) is measured and readout, The Innovation i did was to measure the current in Vref and not Vin of ICL7107, this made the 1/x computation.

Also using the ICL7650 Chopper Stabilized amplifier must be done as shown in data sheets with grounded guard rings. pA will leak on the PCB itself if layout is not done keeping this in mind.