DMM range and AC-DC mode Logic
This is the third circuit that you will need to build a Simple Benchtop DMM with no Microcontroller. Here the U1D and U1B 4093 acts like a de-bouncing circuit for the push keys. The...
Author: delabs
Inverting Amplifier – Op-Amp Circuits
Input Impedance of this module is Ri as pin 2 is at virtual ground, the opamp with feedback tries to maintain pin 2 and 3 at same potential pin 3 is at 0V hence...
Digital Programmable Gain Amplifier
I read your post which is about, Digital gain control of Op-amp. I have some questions to ask, if possible. Please reply ASAP. I am student and I have a lab project to work...
Power supply with battery backup – DMM
This is a simple charger circuit which will work for a light load like a DMM, the Battery can be a sealed maintenance free battery of 9V-2AH or better. The circuit will work best...
Single Polarity Power Supply
This circuit uses a PNP Power Transistor TIP2955, you can use any other according to your current and voltage requirement. Look at R2 a 10 Ohm resistor, when the current in your load to...
Archer Project Board Power Supply
This board provides 5 volt or 13.8 volt power. may be built up as a 5 v/13.8 v dual power supply. This board has LM317 and make a nice Laboratory bench supply. Thanks...
Running Lights with CD4017
The 555 Astable generates a clock for this circuit, an oscillator giving a square wave output at pin 3 which is counted by 4017 to give a running lights effect. Digital Timers Counters and...
Isolated Full-duplex Serial Interface
I would like to build Optoisolated RS232 interface. I’vesearched a little bit, and I came across your design:
