# Analog (Page 3)

## Differential Amplifier – Op-Amp Circuits

This amplifies the difference between two inputs Vp and Vn the low impedance of this configuration is a drawback, but can be used in analog computing. Optimum VCC VDD can be +12/-12. AC signals common to Vp and Vn are canceled by this configuration.

Use a capacitor like 10nF plastic from pin 2 to 3 or across R2 to make circuit stable. For AC applications use LF351 TLO71 as they have good slew rate and also are FET inputs. For AC applications use a capacitor (1uF) in series with Ri to block DC Components. The Inputs have asymmetrical input impedance this affects CMRR, also use 1% tolerance MFR resistors for Rf and Ri.

### Vout = (Vp – Vn) * (Rf/Ri)

Instrumentation and Measurement Circuits

## Inverting Amplifier – Op-Amp Circuits

Input Impedance of this module is Ri as pin 2 is at virtual ground, the opamp with feedback tries to maintain pin 2 and 3 at same potential pin 3 is at 0V hence pin 2 is at virtual ground. Clamping diodes protect OpAmp, Rf + Ri is between 5kE and 1ME as an opamp may be able to drive around say 5mA max.

Inverting Amplifier – Op-Amp Circuits

Current into node pin 2 = Vin/Ri if Vin is +ve it raises potential at pin 2, in order to bring it to 0V the OpAmp sucks away the current by turning its output negative the current leaving pin 2 node is also Vin/Ri. Then Vout is given by Vin/Ri * Rf as per V=IR ohms law. Most OpAmps output swings around 1v less than VCC/VDD for full swing use CA3130 this is a FET input OpAmp, and has low bias currents in pico amps.

### Vout = Vin * (-1) * (Rf/Ri)

Precision Amplifier with Digital Control